DINITROL RC900 - Rust Convertor – 400ml Aerosol
Overview
Dinitrol RC900 - Specialist Rust Convertor & Primer
High-performance rust converter penetrates 7–10 times deeper into the rust than conventional rust conversion products
DINITROL RC 900 is a rust converter based on organic chelate complex combined with epoxy resin. It actively converts the rust on the substrate into a stable organic iron complex. When the product dries, it forms an impenetrable barrier to further corrosion. DINITROL RC 900 penetrates about 7–10 times deeper into the rust than conventional rust conversion products and forms a dry and strong adhesive film that is suitable as a base for the lacquer structure and as a carrier for other corrosion protection products.
Characteristics:
DINITROL RC 900 forms a dry and strong adhesive film which is suitable as a base for paintwork and other corrosion protection products.
Areas of Application:
DINITROL RC 900 has been developed for use on oxidised iron parts.
Method of Use:
Remove rust, grease and dirt with a wire brush, sand paper or a sandblasting process. Rust and scale may only be visible as slight shading. In addition to rust, the steel must also be free from dust and grease. Carefully clean with acetone or lacquer thinner. Shake the spray can well. The product should be applied in several successive coats, at a distance of approx. 25 cm. The metal temperature should not be below 10°C. The material is dust-dry after one hour; if necessary, a further coat can be applied.
Technical data:
- Colour: amber-coloured solution
- Film type: hard
- Density: 0.9 g/cm³
- Viscosity: ~ 118 cm centistokes
- Solids: 16%
- Empfohlene Schichtstärke: 130 µm
- Yield: ~ 60 g/m² per coat
- Drying time: 24 hours at 20°C
- Storage time: 18 months (between 15°C and 25°C)
Specifications
Characteristics:
DINITROL RC 900 forms a dry and strong adhesive film which is suitable as a base for paintwork and other corrosion protection products.
Areas of Application:
DINITROL RC 900 has been developed for use on oxidised iron parts.
Method of Use:
Remove rust, grease and dirt with a wire brush, sand paper or a sandblasting process. Rust and scale may only be visible as slight shading. In addition to rust, the steel must also be free from dust and grease. Carefully clean with acetone or lacquer thinner. Shake the spray can well. The product should be applied in several successive coats, at a distance of approx. 25 cm. The metal temperature should not be below 10°C. The material is dust-dry after one hour; if necessary, a further coat can be applied.
Technical data:
- Colour: amber-coloured solution
- Film type: hard
- Density: 0.9 g/cm³
- Viscosity: ~ 118 cm centistokes
- Solids: 16%
- Empfohlene Schichtstärke: 130 µm
- Yield: ~ 60 g/m² per coat
- Drying time: 24 hours at 20°C
- Storage time: 18 months (between 15°C and 25°C)
Reviews
There are no reviews yet.